Velux GGU INTEGRA Instrukcja Użytkownika Pobierz pdf (Strona 44)

Integration – more windows

44 VELUX

Installation along roof ridge

When choosing ﬂashing for installations along roof ridge, the sim-

plest solution is to use standard ﬂashings (EDW, EDL, EDS) on each

side of the roof combined with a roof ridge kit (EKW --0 --88) to

ensure a watertight and harmonious integration over the ridge.

In case of more windows installed side by side, standard combi

ﬂashings (EKW, EKL, EKS) are used in combination with one roof

ridge kit for each pair of windows over ridge.

Whether it is single windows or windows in

combination, the top ﬂashing sections must

be adjusted depending on the distance "A".

The distance "A" must be 80-200 mm and

the roof pitch 15°-55°.

Note! Roof ridge kit (EKW --0 --88)

requires a ridge board to support the roof

ridge (especially in slate roofs).

If distance "A" is 200 mm or more, the

standard ﬂashing can be used without any

adjustment. There is enough space for the

top ﬂashing sections and the ridge tiles can

continue uninterrupted.

To make it possible to install the windows

closer to each other, use VELUX over

ridge ﬂashing. This ﬂashing connects two

windows of the same width across the ridge

and makes it possible to position the top

frames of the windows close to the ridge.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 151 152

Brak uwag

Velux GGU INTEGRA Instrukcja Użytkownika Strona 44